1. Meter Cover / Fill Side
1a. Viewing Window
1b. Seed Clean-out

2. Singulator
3. Seed Disc
4. Agitator

5. Teflon Wear Gasket
6. Hold Down Plate

7. Meter Housing / Drive Side with Adjustment Lever & Vacuum

Cover (Exterior)

Cast aluminum cover provides accuracy without variation due to temperature. Easily removable for access to seed discs.

Seed Discs

The 1.5 mm thick flat stainless steel discs with mounted brass agitators make a rigid durable meter. Changing is quick and done without tools.

Cover (Interior)

The spring loaded brass ejector block, shown mounted in the Meter Cover, directs seed release at the same consistent angle for consistent spacing.

Teflon Wear Gasket

The replacement teflon wear gasket maintains a smooth contact surface and seal between
back of seed plate and vacuum side of the meter.

Control Window

A large transparent window aids in fine tuning of the meter for accurate singulation.

Meter Cover / Drive Side with Adjustment Lever & Vacuum

Singulator

The brass singulator eliminates doubles. A spring on the cover maintains positive contact against the disc for optimal singulation, even with small seeds.

Singulator Adjustment Lever controls both vacuum and singulator:

Meter exterior showing adjustment lever.

Meter interior showing seed singulator.

Raise to avoid skips vacuum at full.

Also moves singulator higher for larger seeds.

Lower to eliminate doubles and vacuum reduces.

Also moves singulator lower for smaller seeds.